loyolight
LOYO 7” Dragon Ball Headlights Compatible with Jeep JK JKU LJ CJ TJ 1997-2018
LOYO 7” Dragon Ball Headlights Compatible with Jeep JK JKU LJ CJ TJ 1997-2018
SKU:LY-DE7-002
Couldn't load pickup availability
7 inch Round Headlights for Jeep Wrangler, DOT Approved
- New & Patented Design of LOYO
- The best "Z-shaped" cut off line in the 7 inch headlight market. Modern look and uniform light, no blind area and dim spots.
- Integrated white daytime running light, amber turn signal, high / low beam four lighting mode. Put out a Z pattern on low beam that assist not to blind oncoming vehicles.
- Last-Long Quality: High intensive and super bright Osram chips equipped, with 8000LM high beam and 4000LM low beam. Bright and last much longer, Best cooling sink design dissipate heat from the LED chips, makes the chips perform perfect and stable.
- Plug & play, IP67 waterproof & non-condensing. Making your vehicles safe driving under any bad environment.
FITMENT
- Jeep Wrangler JK 2 Door 2008-2014; 2016-2018
- Jeep Wrangler JK 4 Door 2008-2014; 2016-2018
- Jeep Wrangler JL 2018-2022, 9 Inch Mounting Brackets are required
- Jeep Wrangler TJ Unlimited/LJ 2003-2005
- Jeep Wrangler TJ 1998-2000; 2002-2005
- Jeep Wrangler CJ-7 1976-1986
- H1&H2 2004-2009 ( H2 needs 9007 male to H4 female adapter, package not included )
Specification
- Voltage: DC 9V~16V
- Lens material: PMMA+PC
- Led chip: High intensity led chip
- Material: Die-cast aluminum housing
- Luminous flux: 4000LM@Low beam, 8500LM@High beam
LOYO 7” Dragon Ball Headlights Compatible with Jeep JK JKU LJ CJ TJ 1997-2018
Makes a razor clean line of light that avoids drivers in the oncoming lane. They look beautiful and do their job well.
so far i lke these lights as they were very easy to install, and look great
Simple to install on Jeep Wrangler, to date all functions work all. High quality product. Would purchase this product again.
Just installed on my 2-door 2014 JK Wrangler. Fitting the headlights in was no problem - take the grille off, take 4 screws out of each of the old headlights, drop in the new ones with the included wiring adapter and re-use the old headlight rings to secure in place.
The instructions for the daylight running lights and turn signal feature do not help at all, however. The instructions simply state to connect both to the fuse box. What I did was buy a fuse tap or "add-a-circuit" for the running lights, and spliced the wires from each headlight to it. Then found a location in the fuse box for something that would only be on if the car was running or in accessory (can't remember which spot, tbh). For the turn signal function, I spliced that wire into the existing turn signal wiring of the Jeep.
Everything works great, my only complaint is that I had to do a bit of digging online to figure out the install. The instructions stating that the turn signal leads should be attached to the fuse box, as the running lights are, just didn't make any sense. They're a great set of lights though, very bright, very cool looking with the halo.
If you're worried about wiring to the fuse box and splicing into other wiring - you could just plug them in with the included harness and they would work just fine as on/off headlights.
