Jeep Wrangler JK & JKU LED Tail Lights Replacement
The factory tail lights on the Jeep Wrangler JK were never the brightest — and after years of trail use, sun exposure, and vibration, the housings yellow, crack, and the incandescent bulbs burn out. Upgrading to LED tail lights is one of the most popular and practical modifications JK owners make: brighter brake light output, instant-on response, lower power draw, and a cleaner look that holds up for the life of the vehicle.
LOYO's LED tail lights for the JK and JKU are direct plug-and-play replacements for all 2007–2018 models — Sport, Sahara, Rubicon, and Unlimited — with no wiring modifications required. Each set covers brake light, running light, turn signal, and reverse light in a single sealed housing rated IP67 for waterproofing.
The JK was produced in two different wiring configurations depending on the market it was sold in. Getting this wrong is the most common mistake when ordering JK tail lights online.
US Spec (North America): Uses a 4-pin connector. The brake light and turn signal share the same circuit — turn signals flash red. If you bought your JK new from a US or Canadian dealer, this is almost certainly your spec.
Euro / Export Spec (Europe, Middle East, Australia): Uses a 6-pin connector with a dedicated amber turn signal circuit — legally required in these markets. The connector orientation is also reversed compared to US spec.
Not sure which you have? Pull off one factory tail light and count the pins on the body-side connector. Four pins = US spec. Six pins = Euro/Export spec. Takes two minutes and removes all guesswork.
Most JK owners complete the tail light swap in under 30 minutes with a basic screwdriver. The housing mounts in the same location as the factory light, and the plug connects directly to your existing wiring harness.
One thing worth knowing: some JK owners experience hyperflash after switching to LEDs — the turn signals blink faster than normal because the LED draws less current than the incandescent bulb the relay was calibrated for. LOYO's tail lights include built-in load resistors to address this, but if you still see hyperflash after install, an LED-compatible turn signal relay is a simple and inexpensive fix.
Compatible Jeep Wrangler JK Models
Our JK tail lights are compatible with all two-door JK and four-door JKU (Unlimited) models from 2007 through 2018, including:
- 2007–2018 Jeep Wrangler JK Sport
- 2007–2018 Jeep Wrangler JK Sahara
- 2007–2018 Jeep Wrangler JK Rubicon
- 2007–2018 Jeep Wrangler JKU Sport (Unlimited)
- 2007–2018 Jeep Wrangler JKU Sahara (Unlimited)
- 2007–2018 Jeep Wrangler JKU Rubicon (Unlimited)
